1. Theleather dryerrelies on the cyclone conversion in the heating bin to volatilize the moisture in the body. Therefore, the heating bin should have excellent tightness. If it is found that the heating bin of the dryer is not tight, we can weld the head cylinder section and the dryer cylinder after adjustment, and then install the split retaining ring on the simplified characters on the top of the head with anchor bolts. Then, after the sealing flange is placed at a suitable position, it is constructed with the boiling furnace frame and filled with furnace bricks outside the sealing. Then install the spring blade with a steel knife. In order to wear out the simplified characters of the bulletproof spring, an 8mm thick steel plate cylinder section protective wire sleeve is specially installed on the cylinder section 7, and the galvanized steel wire rope is used to hang the hanging object around the spring sheet. Through this solution, the sealing and tightness of the heating chamber can be ensured.

2. During the actual operation of the leather dryer, the cylinder shakes because the side of the concave connector of the rolling ring is not clamped. The cleaning method is to use the cushion block to keep the rolling ring and the concave connector symmetrical and moderately clamped. If it is too tight, it is very easy to cause safety accidents.

3. The transmission chain of the leather dryer is broken. The key of theleather machineryis due to the excessive load borne by the scraper at work and the erosion of the transmission chain by the water in the machine slot, which will reduce the transmission chain and cause the fracture of another transmission chain. Naturally, if the manufacturer in order to better reduce the product cost, high efficiency and reduce the manufacturing quality of the transmission chain, it will also cause the transmission chain to break. However, customers and partners should pay attention to the maintenance of the transmission chain in the whole process of applying the dryer, and appropriately improve the raw materials to prevent excessive load on the transmission chain.

4. It is not easy for raw materials to make "repeated movement" in the barrel of the dryer. Because the "repeated movement" of raw materials in the dryer and "lattice multi control loop fitness exercise" are two different definitions of the production process, the raw materials in the barrel will be quickly sucked away by the wind. As a result, the storage capacity of raw materials in the barrel is too low, As a result, the total contact area between raw materials and warm air dynamic and static data is reduced.

5. The reason why the temperature in the leather dryer can not be raised: the vent is opened too large and the exhaust is too fast. Cleaning method: cover half of the thick paperboard with the filter screen and half close the air inlet valve.

6. Cause of too low rotating speed ratio of inner drum of dryer: insufficient tension distance of triangular adhesive tape cleaning method: adjust adjustable components to increase tension distance